| M-TEST Files |
M-TEST
Defaults File
The M-TEST Defaults file—as referred to in
Section 5.2.2 of the
M-TEST 5.0 User's Manual and Appendix F of the DSP6001
User's Manual—contains default values for
all parameters used in testing with Magtrol Dynamometers
and Torque Transducers.
After downloading, unzip the file and save the M-TEST
Defaults.txt file to the same directory where M-TEST 5.0 is located.
If you need this information to configure your DSP6001
but do not have M-TEST 5.0, the text file
can be imported into any spreadsheet or database
program and the default values can be manually programmed
into the DSP6001 via the front panel menu system.
• M-TEST 5.0 Defaults
M-TEST Language File
Language File.csv—as referred to in Section
4.2.1 of the M-TEST 5.0 User's Manual—contains
the default language dictionary for M-TEST 5.0 (English,
French, German, Spanish and Chinese).
After downloading, unzip the file and save "Language
File.csv" to the same directory where M-TEST 5.0 is located.
• Download
M-TEST Language Dictionary •
|
|
| DSP6001 Files |
Installation Instructions:
After downloading the desired program, unzip the
file and run the setup.exe program. All of
the default selections can be used (folder, etc.).
After installing the program, restart your computer.
DSP6001 Setup*
This is a "getting started" program to load all
of the default parameters for the dynamometer in
use. Parameters such as maximum speed, maximum torque,
maximum power, encoder, torque filters, PIDs, alarms,
etc. will be programmed into the DSP6001 and saved
to nonvolatile memory. This allows the user to simply
plug in a dynamometer and start operating it with
the DSP6001 without going into complicated setup
menus. The program will communicate with the DSP6001
by either the Serial or GPIB port (whichever the
user has).
• Download
DSP6001 Setup (620 KB) •
*Please Note:
The DSP6001 Setup is a LabVIEW™ program. You must first download
and install the RunTime module before using
DSP6001 Setup.
• Download
Runtime (2.54 MB) •
|
|
