TSC 401 Torque/Speed Conditioner

TSC 401

Product Description

The TSC 401 is the Torque/Speed Conditioner used to connect Magtrol Eddy-Current (WB) or Powder (PB) Dynamometers to the DSP7000 Dynamometer Controller. Powered by the dynamometer controller, and based on a precision instrumentation amplifier, the unit amplifies and filters the torque signal. It also provides power and connections for the speed pickup sensor which is located in the dynamometer.

Specifications

CharacteristicValueComment
Supply Voltage± 20 V to ± 30 VN/A
Supply Current40 mA nominal; 45 mA maxWith a 350 ohm load cell bridge and no O/P load.
Torque O/P Voltage5 VDC ± 0.2 %Rated dynamometer torque.
Offset± 0.2 % FSDN/A
Symmetry± 0.1% FSDN/A
Bandwidth (3 dB single pole)20 HzN/A
Max O/P Current5 mAWithout distortion.
Min O/P Load1 kilohmsN/A
Offset Drift< 100 ppm/°CN/A
Sensitivity Drift< 50 ppm/°CN/A

 

Ordering Information

It is important to specify which dynamometer will be used with the TSC 401 Torque/Speed Conditioner so that it can be delivered with the appropriate cables. Because The TSC 401 also requires calibration with its associated dynamometer, it is suggested that the dynamometer and Torque/Speed Conditioner be ordered together in order for Magtrol to perform this calibration before leaving the factory.

If purchased separately, the part number and serial number of the customer’s dynamometer must be specified so that Magtrol can ship a pre-configured TSC 401. The customer must then perform the (Zero, CW & CCW) calibration on site, as outlined in the TSC 401 User’s Manual.

DynamometerTorque/Speed Conditioner P/N
WB/PB 2.7, 43234-401-000-11x
WB/PB 65, 115, 15234-401-000-12x