Designed to work with all TM,
TMHS, and TMB In-Line Torque Transducers, this easy-to-use
device powers the torque meter and utilizes high speed Digital
Signal Processing (DSP) to display torque, speed, mechanical
power and direction of rotation. The 6400 can be used as a
basic display, as an interface with Torque
1.0 Software or on the production line using its pass/fail
feature. The unit includes an auxiliary analog input for the
option of testing with an additional transducer and a special
tare function to help offset any slight residuals caused by
couplings or suspended loads. The 6400 also has IEEE-488 and
RS-232 interface capabilities, allowing a PC-controlled environment
that can yield high data acquisition rates of up to 100 torque
and speed readings per second.
Features
- For use with all Magtrol TM, TMHS and TMB In-Line
Torque Transducers
- Pass/Fail Testing for torque, speed and auxiliary
input
- BITE: Built-In Test Equipment
- RS-232 & IEEE-488 Interfaces
- High Speed Data Acquisition: 100 torque and speed
readings per second via IEEE bus
- High Quality, Easy-to-Read Vacuum Fluorescent Readout:
Displays torque, speed, power and direction of rotation
|
- Torque Measurement Options: Standard English, metric
and SI settings
- Overload Indication
- Tare Function
- Internal Data Storage: Up to 100 data points
- Auxiliary ± 10 VDC Analog Input for additional
transducer
- Access to TM signals via back panel BNC connectors
- Includes Magtrol Torque
1.0 Software
- Closed Box Calibration
- 19" (482.6 mm) Rack Mounts with Handles
|
Pass/Fail Motor Testing
The Model 6400 comes with an easy-to-use
motor testing Pass/Fail feature. This feature is ideal for
quick pass/fail (go/no go) testing in production and incoming
inspection applications. When the 6400 is operated in the
Pass/Fail mode, one of three readings is used as the tested
parameter: torque, speed or auxiliary transducer. The two
parameters not used are set with user defined upper and lower
acceptable limits. As the motor is loaded to the tested parameter
value (for example, speed), the other two parameters (in this
case, torque and transducer) will indicate PASS or FAIL. The
display will show pass or fail, or can be toggled to display
the actual values.
|
