Installation Instructions:
After downloading the desired program, unzip the
file and run the setup.exe program. All of
the default selections can be used (folder, etc.).
After installing the program, restart your computer.
DSP6001 Setup*
This is a "getting started" program to load all
of the default parameters for the dynamometer in
use. Parameters such as maximum speed, maximum torque,
maximum power, encoder, torque filters, PIDs, alarms,
etc. will be programmed into the DSP6001 and saved
to nonvolatile memory. This allows the user to simply
plug in a dynamometer and start operating it with
the DSP6001 without going into complicated setup
menus. The program will communicate with the DSP6001
by either the Serial or GPIB port (whichever the
user has).
• Download
DSP6001 Setup (620 KB)
*Please Note:
The DSP6001 Setup is a LabVIEW™ program. You must first download
and install the RunTime module before using
DSP6001 Setup.
• Download
Runtime (2.54 MB)•
|
