 |
The TSC 401 is the Torque/Speed
Conditioner used to connect Magtrol Eddy-Current
(WB) or Powder
(PB) Dynamometers to the DSP6001
Dynamometer Controller. Powered by the DSP6001, and
based on a precision instrumentation amplifier, the unit
amplifies and filters the torque signal. It also provides
power and connections for the speed pickup sensor
which is located in the dynamometer.
Ordering Information
It is important to specify which dynamometer will be used
with the TSC 401 Torque/Speed Conditioner so that it can
be delivered with the appropriate cables. Because The
TSC 401 also requires calibration with its associated
dynamometer, it is suggested that the dynamometer and
Torque/Speed Conditioner be ordered together in order
for Magtrol to perform this calibration before leaving
the factory.
If purchased separately, the part number and serial number
of the customer's dynamometer must be specified so that
Magtrol can ship a pre-configured TSC 401. The customer
must then perform the (Zero, CW & CCW) calibration on
site, as outlined in the TSC 401 User's Manual.
| Dynamometer |
Torque/Speed Conditioner
P/N |
| WB/PB 2.7, 43 |
234-401-000-11x |
| WB/PB 65, 115, 15 |
234-401-000-12x |
|
|
|
