| TABLES
FOR HD / ED DYNAMOMETERS |
 |
 |
 |
 |
| For HD-100, 400, 500 and
700 Series Dynamometers with short base plate and ED-715
Dynamometers* |
For HD-100, 400, 500 and
700 Series Dynamometers with long base plate |
For HD-800 Series Dynamometers
with long base plate and ED-815 Dynamometers* |
For HD-825 Dynamometers
with long base plate |
| Grooved table top with
five M10 T-slots: one centered, two 250 mm apart and two
350 mm apart. |
Mounting holes are pre-drilled
and tapped.
|
Base of dynamometer also
serves as the table top.
|
Grooved table top with
three M12 T-slots: one centered and two 250 mm apart.
|
| For tables ordered with
HD-710 and HD-715 Dynamometers, blowers will be shipped
mounted under the table top.** |
For tables ordered with
HD-710 and HD-715 Dynamometers, blowers will be shipped
mounted under the table top (as shown).** |
For tables ordered with
HD-810 and ED/HD-815 Dynamometers, a blower mounting hardware
kit will need to be purchased if under-the-table mounting
(as shown) is desired. Assembly required. |
For tables ordered with
HD-825 Dynamometers, a blower mounting hardware kit will
need to be purchased if under-the-table mounting (as
shown) is desired. Assembly required. |
| TAB 1457S |
TAB 1457L |
TAB 0800L |
TAB 0825L |
|
|
| TABLES
FOR WB / PB DYNAMOMETERS |
 |
 |
 |
 |
| For WB/PB 43 Series Dynamometers |
For WB/PB 65 Series Dynamometers |
For WB/PB 115 Series Dynamometers |
For 1 & 2 WB/PB 15 Series
Dynamometers |
| Grooved table top with
five M10 T-slots: one centered, two 160 mm apart and two
350 mm apart. |
Grooved table top with
three M12 T-slots: one centered and two 250 mm apart. |
Grooved table top with
three M12 T-slots: one centered and two 250 mm apart. |
Grooved table top with
three M14 T-slots: one centered and two 250 mm apart. |
| TAB 0043 |
TAB
0065/0115 |
TAB
0065/0115 |
TAB 0015 |
| CUSTOM TABLE EXAMPLES |
 |
 |
| Lift table suitable for WB/PB 115 Tandem Dynamometers |
For 3 & 4 WB/PB 15 Series
Dynamometers |
• Dynamometer, TSC, DES and EK control mounting provisions
•
10" (254mm) total travel accommodates various motor center heights
•
4-point locking for position stability
•
Smooth vertical motor height adjustment
•
DIN 650-14 H12 T-slots
•
Welded steel construction
•
3" x 3" x 1/4" tubular frame |
•
Dynamometer, TSC, and DES mounting provisions
• DIN 650-14 H12 T-slots, one centered and two 250 mm apart
• Welded steel construction
• 3" x 3" x 1/4" tubular frame |
| TAB
0115 TL |
TAB
3415 |
