| Two
Channels: |
Enable the
unit to support up to two testing instruments with independent
or tandem configurations. |
| Built-in
Alarm System: |
For power,
speed, torque, temperature, air flow, water flow, electrical
overload and external inputs |
| Torque/Speed
Analog Outputs: |
For interface
with a data acquisition system or strip chart recorder |
| Two
Standard Computer Interfaces: |
RS-232 and
IEEE-488 |
| High
Speed Data Acquisition: |
120 torque
and speed points per second via IEEE bus
(approx. 60/sec. via RS-232) |
| High
Quality, Easy-to-Read Vacuum Fluorescent Readout: |
Displays
torque, speed, power, auxiliary and PID (proportional
gain, integral and derivative) values |
| Fast
Full-Curve Data Acquisition: |
Free-run to
locked rotor in seconds |
| Speed
& Torque Operating Modes: |
Provide independent
PID settings for improved Dynamometer control |
| Built-in
Current-Regulated Supply: |
For use with
Hysteresis Dynamometer only |
| Adjustable
Torque Units: |
English, Metric
and SI are standard |
| Dynamometer
Overload Protection |
--- |
| Digital
Filter: |
Removes undesired
noise from torque signals |
| Cross
Loop Function: |
Allows closed
loop control of brake via torque transducer |
| Programmable
Digital PID Values: |
Controlled
and stored via M-TEST
software or controlled manually |
| Saving: |
Saves programmed
values within configuration |
| Auxiliary
± 10 VDC Analog Input: |
For additional
transducer |
| Single
or Multi-point Torque and Speed Stabilized Testing: |
Via M-TEST
software |
| Calibration: |
Closed box
calibration |
| Rack
Mounting: |
19 in (482.6
mm) rack mounts with handles |
Magtrol's Model DSP6001 High-Speed
Programmable Dynamometer Controller employs state-of-the-art
Digital Signal Processing Technology to provide superior motor
testing capabilities. Designed for use with any Magtrol 
